BEST WALL ANCHORS FOR PLASTER AND LATH CRACK

The major problem when fixing to lath and plaster is the fact that there isn’t anything strong to fix to. Image coutesy of Museum Resources The Problem of Fixing to Lath and Plaster When this happens, holes can easily form and the surface becomes very unstable and often becomes powdery to the touch.Ī section of a lathed wall with plaster removed. As the laths are very flexible they allow the wall to move, and as the plaster has degraded it often crumbles behind and in between the laths. The gaps between the laths allow the plaster to be pushed in, where is spills out behind each lath and once set, clings there forming a flat and solid surface.ĭespite this however, most lath and plaster walls and ceilings in homes in this country are at least 60 years old and due to this are well past their “sell by” date.

It became widely used and started to replace lath and plaster by the 1930’s.Īs mentioned, to create a lath and plaster finish, the plaster is pushed onto and into the timber laths, which have been nailed to upright studs. Plasterboard took a while to catch on and was introduced to the UK in 1917. Lath and plaster is an extension of the wattle and daub idea and was used long after the invention of plasterboard by Augustino Sackett in approximately 1888. The daub was pushed, usually by hand, into the web of branches to forming a weatherproof surface, protecting the inside of the dwelling. Wattle was the name for twigs and branches that were interwoven between the upright timber posts that formed the framework of a dwelling.ĭaub was the name given to the various forms of mud, clay, lime, manure or other locally available, easily workable fillers that could be applied and smoothed onto the wattle. Lath and plaster was used as a wall finish long before plasterboard took over from the centuries old Wattle and Daub finish. It uses thin strips of timber spaced and fixed an inch or so apart that’s then fixed to a stud work frame that provides a surface for plaster to be applied to. Lath and plaster is a type of traditional wall finish, similar to plaster, that was first used around the 1700’s all the way up to the mid 18th century.

The plaster immediately ruined any other bit.Īlso, with my old house, a stud-finder was essentially useless due to the plaster thickness/composition.Fixing to lath and plaster walls has always been a tricky problem and one that has always puzzled first time DIY’ers, however there are several solutions to this conundrum which we run through below. I used a high-quality bit for drilling in ceramic, too.

BEST WALL ANCHORS FOR PLASTER AND LATH CRACK

Patience is key you don't want to rush and potentially crack the plaster or break the bit off in the wall. I would mark the spot for the nail/hanger, place masking tape around that area, then with a very small bit I would cautiously drill a hole as described above. While it was well-constructed, there was no consistency to the thickness of the plaster throughout the home. My first house was approximately 100yrs old and had the old 'horsehair' plaster. Adamthesmythe wrote:I use a small drill, slightly smaller than the nail for a hanger drill a hole angled downwards hammer anchor in gently.

Best wall anchors for plaster and lath